13
Permanent Mounting
1. Place the mounting hardware at the selected location. Orient any cable exit in the
direction that you want the cable to travel (Figure 4).
2. Position the mounting hardware at a 90° angle to the mounting surface. If
necessary, use shims to make the mounting surface level.
3. Mark the holes for the mounting screws. If the cable will pass through the
center of the mount, also mark that hole.
NOTE
: If you are using a ratchet mount, be sure you have purchased an
extension with a cable pass-through. Do not use a ratchet mount with the
200WXRS or 200WXS that has a solar shield.
4. Drill the holes for the mounting screws and the cable exit if necessary. If the
cable is to be fed through a deck, install a high quality deck gland.
5. Using purchased screws, fasten the mount in place.
6. Screw an extension tube onto the antenna mount if desired.
Figure 4. Installation
(150WX shown)
nut assembly
extension tube
antenna mount
cable exit
alignment
(some installations)
(most installations)
(some installations)
notch
lower housing
Copyright © 2007 - 2018 Airmar Technology Corp.
