9
2. Decide if you want the cable to exit through the center or along the side of the
pole/rail bracket. Slide the nut assembly onto the end of the cable at the sensor
connector.
Do not connect the sensor at this time.
a.
Center exit
—Pass the
sensor
connector end of the cable through the center
of the pole.
Be sure to leave several inches of cable extending beyond the
nut assembly.
b.
Side exit
—Place the cable side-exit adapter (part D) over the cable.
Being
sure the cable is passing through the slot in the side, s
crew the nut assembly
onto the adapter.
Hand tighten
only. Do not over tighten.
NOTE: Use the adaptor supplied as it has smooth edges that will not chafe the
cable. Do not use a purchased part.
3. Screw the extension pole/rail bracket onto the nut assembly /side-exit adaptor.
Hand tighten
only. Do not over tighten.
4. Remove the protective cap from the
sensor
connector on the cable. (Save the
cap to protect the connector when the receiver is removed.) Plug the cable
firmly into the sensor.
5. With the alignment tab on the sensor facing forward and parallel to the
centerline of the boat / vehicle, slide the captive nut upward and screw it onto
the mount base.
Hand tighten
only. Do not over tighten.