7.2 SMTP
Set the SMTP menu when you want to send an image via e-mail. By using Mail (SMTP) function, you can send
a mail with attached image which has been shot linked with the external sensor input or with the built-in motion
detection function. The image file can also be sent periodically. E-Mail (SMTP) setting menu is composed of
three tabs,
General
,
Alarm sending
and
Periodical sending
.
7.2.1 General
Select
On
when you use the SMTP function. The common setting options are displayed below. If you do not
wish to use the e-Mail (SMTP) function, select
Off
and click
OK
.
Note
：
• During transmission of an image file via mail, the frame rate and operation performance of the monitor
image of the main viewer decline.
• While the camera video mode is set to
MPEG4
, the image of the composite video signal output from the
video output connector of the camera may be distorted during mail transmission.
• You cannot send an audio file by using the mail sending function.
z
SMTP server name
：
Type the SMTP server name up to 64 characters, or the IP address of the SMTP
server.
z
Authentication
：
Select the authentication required when you send an email.
z
Off:
Select if no authentication is necessary when an email is sent.
z
On:
When authentication is necessary an e-mail is sent, select one of the authentication methods from the
followings.
z
SMTP:
Select if SMTP authentication is necessary when an e-mail is sent.
z
POP before SMTP:
Select if POP before SMTP authentication is necessary when an e-mail is sent.
Note
：
• When you set to
On
, be sure to select either or both
SMTP
or/and
POP before SMTP
.
POP server name
：
It is necessary when the
POP before SMTP
is selected in
Authentication
. Type the
POP (receiving mail) server name up to 64 characters, or type the IP address of the POP server. This
setting is necessary when the SMTP server which sends e-mails performs authentication using the POP
user account.
28
AirLive POE-100CAM User’s Manual
