Operation
3A1183C
7
Operation
Setup
Connect the hose and gun
1.
Remove the plastic cap plug from the outlet and
screw a conductive or grounded 3000 psi spray
hose onto fluid outlet.
2.
Connect an airless spray gun to the other end of the
hose. Do not install spray tip.
NOTE:
Do not use thread sealer on swivel unions as
they are made to self seal.
Fill the Packing Nut/Wet Cup
1.
Fill the Packing Nut with 5 drops of ASM Packing
Seal Fluid.
Flush the Sprayer
1.
Flush the sprayer. See
Flushing Procedure
on
page
7.
Prime and Flush Storage Fluid
Before beginning a new spraying project you need to
prime the sprayer and flush the storage fluid out of the
sprayer.
Oil- or Water-based Materials
•
When changing from water-based
material to oil
based material, flush with soapy water and then
mineral spirits.
•
When changing from oil based material to water
base material, flush with mineral spirits, followed by
soapy water, then a clean water flush.
•
When flushing with solvents, ground pail and gun.
•
Flush before changing colors, before fluid can dry in
the equipment, at the end of the day, before storing,
and before repairing equipment.
Flushing
1.
Make sure the gun trigger lock in engaged and there
is no spray tip in the gun. Refer to the separate
• To reduce the risk of static sparking, fire or
explosion which can result in serious bodily injury
and property damage, always ground the sprayer
and system components and the object being
sprayed, as instructed in the safety warning section
of this manual.
• Ensure electrical service is 120 VAC, 20 amp
minimum and the outlet is properly grounded.
• For generator power, a minimum 7000 watt
generator with a voltage regulation must be used.
ti15987a
NOTICE
The equipment was tested with lightweight oil,
which is left in the fluid passages to protect parts.
To avoid contaminating your fluid with oil, flush the
equipment with a compatible solvent before using
the equipment for the first time.
• To reduce the risk of static sparking, which can
cause fire or explosion, always hold a metal part of
the gun firmly against the metal pail when flushing.
This also reduces splashing.
• Always remove the spray tip before flushing.
