www.airkinglimited.com
111597004 New 3-07
1 of 8
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT
YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
electric shock and injury to person, including the following:
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND
INJURY TO PERSON, OBSERVE THE FOLLOWING:
1.
Read all instructions before installing or using range hood.
2.
Use this unit only in the manner intended by the manufacturer. If you have
questions, contact the manufacturer.
Professional Series
Back Splash
SAVE THESE INSTRUCTIONS
3.
Installation work must be done by qualified person(s) in accordance with
all applicable codes and standards, including fire-related construction.
4.
When cutting or drilling into wall or ceiling, do not damage electrical wiring
and other hidden utilities.
5.
Refer to the instructions included with the Range Hood Canopy for additional
safety information.
IMPORTANT INSTRUCTIONS -
OPERATING MANUAL
INSTALLATION INSTRUCTIONS
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL
BEFORE STARTING INSTALLATION.
SECTION 1
Preparing for installation
NOTE:
Before installing back splash, make sure all component of the rest of the
installation including the range hood and any optional soffits have been measured
properly and accounted for. See “Range Hood Mounting Instructions”.
1.
Unpack back splash from the carton and confirm that all pieces are present.
In addition to the back splash top and bottom piece, you should have:
All Models:
9 - #8 Screws
9 - Wall Anchors
1 - Instruction/Safety Sheet
Models with Shelves also include:
2 - Wire Shelves
4 - Shelf Mounting Brackets
8 - Screws
NOTE:
Some back splashes may be shipped with a protective plastic adhered
to the back splash. It is recommended to leave this in place during installation
to protect from scratching. Remove when the installation is complete.
2.
Determine where the bottom of the hood will be located and mark a level
line 17 3/4" below it. Hold the bottom section of the back splash (flat section)
up to the line you just marked. Make sure the section is centered side to
side and mark the location of the holes on the line
(Figure 1)
.
NOTE:
Make sure you center the holes in the bottom back splash section on
the marked line. DO NOT use the line to level the top of the back splash.
SECTION 2
Installation
NOTE:
Confirm that the bottom section of the back splash will be level and
centered with the cook top.
1.
Install the included wall anchors by drilling into the wall at the locations
that where marked earlier
(Figure 2)
.
Bottom Section
17 3/4"
Bottom of Hood
Figure 1
::
rangehoods
.
com
Call 1-800-667-8721 anywhere in the US and Canada
-
www.rangehoods.com
Air King at
::
rangehoods
.
com
is a division of
kitchen
::
accessories
U N L I M I T E D
