0
05
10
15
20
30 m
25
95
90
55
45
05
0
10 15 20 25 30 35 40
60
50
65
75
70
80 85
100ft
1. Cut out shape to remove yellow areas.
2. Fold along the lines where indicated. Where indicated by solid red arrows fold back-to-
back; where indicated by white arrows, fold front-to-front.
3. Insert Port Engine tabs 01 and 02 into slot 03. Adhere tabs to non-printed interior of Wing.
4. Insert Starboard Engine tabs 04 and 05 into slot 06. Adhere tabs to non-printed Wing interior.
5. Insert Gear tabs
07 and 08 into
Wing slot 09
and tabs 10 and
11 into Wing slot 12.
Adhere tabs to non-printed
interior of Wing.
6. Apply glue to non-printed
surfaces. Stick sides together.
7. Adhere the two halves of section
13 back-to-back.
8. Adhere the two halves of tab
14 back-to-back.
9. Place tab 14 inside the forward
Fuselage between points 15 and
16.
1. Cut out shape to remove yellow areas.
2. Fold along lines where indicated. Where solid red
arrows, fold back-to-back; where white arrows fold
front-to-front.
3. Apply glue to non-printed surfaces. Stick together.
4. Insert Hor. Stb. into rear Fuselage at point 23.
Insert tab 19 inside the Fuselage.
AIRBUS A220-300 / KOREAN AIR
7GKAL21L05
Paper-based scale model design system Copyright © 2021
—
Airigami / Airline designs and logos are reproduced for Fair Use
educational and informational purposes. USE OF THIS TEMPLATE FOR FINANCIAL GAIN IS PROHIBITED.
1. Cut out shape to remove yellow areas.
2. Fold along lines where indicated. Where solid red arrows, fold back-
to-back; where white arrows fold front-to-front.
3. Apply glue to non-printed surfaces. Stick sides together.
4. Insert Port Engine tab 01 and tab 02 into Wing slot 03.
5. Insert Starboard Engine tab 04 and tab 05 to slot 06.
1. Cut out shape to
remove yellow areas.
2. Fold along lines where
indicated. Where solid
red arrows, fold back-
to-back; where white
arrows fold front-to-
front
3. Apply glue to non-
printed surfaces.
Stick sides together.
4. Insert tabs 07 and 08
into Wing slot 09
and tabs 10 and 11
into Wing slot 12.
Adhere tabs to non-
printed interior of
Wing.
1. Cut out shape to remove
yellow areas.
2. Fold back-to-back along line
where indicated.
3. Apply glue to non-printed
surfaces. Stick sides
together.
4. Apply glue to printed area 17
where shaded.
5. Place shaded area 17 inside
to forward Fuselage at point
18, forward of tab 20 and 21.
