Mechanical Installation
The ecoDRY mini has to be installed at a minimum height of 120cm (from the ground to the air
outlet/bottom of the dryer). The hand dryer should be positioned at least 60cm from a bathtub,
shower or hand basin. Where multiple dryers are being installed alongside each other, allow
enough space for people to access the dryer. Also, if installing next to an adjoining wall, the
dryer should be positioned at least 200mm from this wall to allow for proper access.
You should ensure that the electrical supply (tension) does not exceed the maximum power of
the apparatus (220-240v). This product is intended for installation by a suitably qualified
person.
Specification
Fan Drying:
20 seconds
Protection:
Class II
Fan Speed:
2800 rpm
Weight:
1.2 Kg
Compliant:
CE, RoHS, WEEE
Operating
The hand dryer comes into operation and automatically stops by hands approaching and
moving away from the cone air outlet.
Warning: In case of an overload of internal temperature, a thermostat with automatic reset
protection suspend the operation of the motor. This device gives the user greater safety of
operation.
The unit has heating element. Air is then heated by the power of motor and heating element.
This dryer allows considerable energy savings compared to traditional dryers, reducing
consumption as our trading indications. In case of overheating a safety thermostat switch off
temporary the heating element.
The device has a system that prevents vandalism continuous operation, caused for example by
covering the photocell. If this occurs, the dryer can work without interruption for about 60
seconds, then automatically stops waiting for (stand by)
It will be simply needed to remove the cover that blocks the photocells to ensure the dryer to
resume its normal function in 3-4 seconds.
Maintenance
Warning: Before performing any maintenance, please disconnect the appliance from the
network.
Clean this dryer using a soft cloth dampened with water and detergent. To ensure the durability
and reliability of this product, periodically check that the grid inlet and outlet of the cone are not
clogged by dust or any equivalent material.
