OPERATORS MANUAL – PSV-8E (GAS)
AIR FLO MANUFACTURING., CO INC.
4 |
P a g e
Installation Instructions
Mounting the Spreader onto the
Vehicle
1.
Install the inverted “V” in the
spreader using the bolts, nuts, and
washers provided. See Figure 6.
2.
Remove the tailgate from the
vehicle.
3.
Lift the spreader by attaching the
lifting device to the slot on the
passenger side of the rear inside
brace.
4.
Place the spreader on top of two
pieces of lumber so that the lumber
rests under the side gussets as
shown in Figure 7.
NOTE: This will
help to remove any excess material
that accumulates under the
spreader.
5.
Lift the spreader and place it in the
back of the vehicle so that it is
centered to the vehicle and the rails
of the spreader are 14” from the
rear of the truck.
6.
Bolt the spreader to the vehicle
frame through side gussets and the
lumber.
7.
Tie the spreader to the vehicle from
the tie-down eyes to the vehicles
anchor points.
Bill of Materials
Figure 6.
Figure 7.
CAUTION
Check the rated maximum payload of
the lifting device before lifting the
spreader.
