INSTALLATION
www.airfieldaudio.com
- 3 -
5
1 2 6 4 3
REAR PANEL VIEW
1.
IMPORTANT
:
SET THE MAINS SWITCH ON THE REAR PANEL TO THE
CORRECT VOLTAGE.
2.
Be certain that the unit has a ½ AMP fuse (115 VAC mains)
or ¼ AMP fuse (230 VAC mains).
3.
Connect a line level audio input cable from your source (microphone preamp, EQ,
guitar or bass preamp / effects box, analog console or analog output from your
DAW) to the 3 pin XLR / ¼” female connector. The input connector is Balanced
Transformer Coupled, pin 2 hot.
4.
Connect an audio output cable to the 3 pin XLR male connector and plug it into
the input of your recording or mixing device. The output XLR is Balanced
Transformer Coupled, pin 2 hot.
5.
Connect the supplied IEC power cable to the IEC mains socket on the rear panel.
USE ONLY A 3 PRONG GROUNDED POWER CABLE. For safety reasons do
not lift the ground on the power plug by using a 3 to 2 ground lift adapter.
6.
Link Jack: connect a standard ¼” unbalanced guitar type cable between 2
Liminator units for stereo operation. Y-cables should be used in a daisy-chain
configuration for multi-channel operation of 3 or more Liminator channels.
7.
Turn on the unit and allow 30 minutes warm up.