4
Line out to fan
a. at wall (Fig.1):
1. Connect supply in from house to wall control
node marked “TO HOT”.
2. Connect line out to fan to wall control node
marked “FAN”.
Note: The “TO LIGHT” node on wall control is
not applicable for this fan.
b. at ceiling (Fig.2):
1. Connect blue wire from fan to terminal block
marked “N”.
2. Connect brown wire from fan to terminal block marked “L”.
3. Connect green wire from ceiling to terminal block marked “ ”.
4. Connect blue wire from ceiling to terminal block marked “N”.
5. Connect line in from wall control to terminal block marked “L”.
AFTER ALL WIRES ARE CONNECTED:
(1) Attach wall control unit to outlet box using the two mounting screws provided.
(2) Attach wall plate to the switch control front.
Note:
Wires from house may vary in color and may not include ground wire (green/yellow).
WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box
and not pinched between the wall plate and the wall.
WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate fan until the blades are in place. Noise and fan
damage could result.
6. Canopy installation
a. Push up the canopy until the two screws on mounting
bracket are engaged with key holes in canopy.
b. Rotate the canopy slightly until the two screw heads
are in the small end of the key holes.
c. Tighten both screws.
Wall Control
Supply in from house
Brown
(AC-L)
From Fan
From Ceiling
Green
Blue
Brown
Brown
Blue
Yellow Green
Canopy
Screw
Key Holes
