Installation Steps :
Fig.1
Turn OFF the electric power at the
main fuse or circuit breaker box.
Left fan fixture set and hang on
mounting plate with hook provided,
through one of the two holes in
canopy. This will allow for
hands-free wiring.
CAUTION: Use only a side with
hole in canopy, not hook slot.
F A N C O
181008
PAGE: 5 / 8
INSTALLATION INSTRUCTIONS
NOTE: The fan weight is 35lbs (15.9kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Fig.4
Fig.5
Fig.7
Hang the safety cable into the
safety cable hook.
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
Fig.6
Twist wire ends together and
screw wire connectors on
in a clockwise direction. tape wire
connectors and wire together.
instructions that the splics after being
made should be turned upward and
pushed carefully up into the outlet box.
Screw the safety cable hook to the ceiling outlet box. Insert wires from the
outlet box through the hole in center of mounting plate. Attach the mounting
plate to the outlet box by using two flat washers and mounting screws.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED " ACCEPTABLE FOR
FAN SUPPORT OF 15.9KG(35LBS) OR LESS"!
Mounting Plate
Outlet Box
Flat Washer
Mounting Screw
Fig.3
.
Fig.2
Safety Cable Hook
Ceiling
Mounting Plate
Fan Fixture Set
Wire Connector
Fan Fixture Set
Make wire connections:
1).The white motor wire to the white
wire from the outlet box with a wire
connector.
2).The black motor wire to the black
wire from the outlet box with a wire
connector.
3). The ground wire from the outlet box
to the ground wire from the mounting
plate with a wire connector.
Safety cable
