F A N C O
180725
Remove the motor screws and
washers from the motor assembly.
Secure blade brackets to the motor
with washers and motor screws.
Attach the canopy to the hanger
bracket, then secure it with four
screws and washers.
Thread the blade screws through the
rubber washer,blade bracket and blade
into the decorative cap. Tighten all blade
screws securely. Repeat to other blade.
Fig.11
Blade
Blade Bracket
Blade Screw
Fig.12
Motor Screw
Blade Bracket
Screw
Hanger Bracket
Washer
Canopy
Fig.10
Blue
Green (Ground)
Fig.8
Make wire connections:
1). The white motor wire to the white wire from the outlet box with a
.
2). The black motor wire and blue wire to the black (hot) wire from the outlet box
with a
.
3). The green (ground) wire from the downrod to the ground wire from the outlet
box with a
.
*** After making the wire connections, the wires should be spread apart with the
grounded wires on one side of the outlet box and the ungrounded wires on the
other side of the outlet box.
*** After the connections have been made, the wires should be turned upward and
pushed carefully up into the outlet box.
Decorative Cap
Rubber washer
Fig.13
Switch Box Screw
Switch Box Cover
Install without fan light
Make sure the wires of the fan light in
the switch box are capped with wire
connectors. Secure the switch box
cover with the switch box screws.
Note: To install the fan light, skip this
step and proceed to Fig.14.
Fan Light Installation:
WARNING:
As per EPACT 2005 requirements, this fan light has a built-in current limiting device to conserve
energy. The fan light will not operate if the combined wattage of the installed bulbs exceeds 190
Watts. If the fan light shuts off shortly after being switched on, it may be due to excessive current
demand. You should replace the light bulbs with lower wattage bulbs.
Hang the safety cable into the safety cable hook.
Fig. 9
Safety Cable Hook
Safety
Cable
