[ 8 ]
Bulb Eater
®
VRS(-U) Premium Manual
800.909.9709
www.aircycle.com
Spinner Replacement Procedures
Adjusting the Lid Sensor
The Bulb Eater® spinner assembly should be changed every 10 drums or as needed.
Gloves and eye protection should be worn while changing the spinner.
With the Bulb Eater
®
on a clean, empty drum:
Carefully stand the Bulb Eater
1.
®
on edge.
With an allen wrench, loosen the set screw holding the spinner on the motor shaft.
2.
Slide off the old spinner and replace with new spinner in the same position.
3.
Tighten the set screw fi rmly to secure the spinner to the motor shaft.
4.
3/16”
Sensor set screw (w/1/8” hex wrench)
(use light pressure)
Use these tools to adjust the open lid and full drum sensors.
If the “Open Lid” light remains on while the lid is closed, use the 1/8” hex wrench to adjust the lid
•
sensor to extend 3/16” from the sensor housing.
If necessary, use the included screwdriver to adjust the sensitivity on the full drum sensor. The factory
•
setting is minimum sensitivity. (Remove control box cover to access sensitivity screw. Reseal bottom of
control box when replacing)
