aircon CSTB-24R32IVT IN, Owner'S Manual, Page: 47 / 60

TIPS FOR USING REMOTE CONTROL
CAUTIONS FOR USING REMOTE CONTROL
•
The remote control must be used within 8
meters of the unit.
The unit will beep when remote signal is
received.
Curtains, other materials and direct sunlight
can interfere with the infrared signal receiver.
Remove batteries if the remote will not be
used more than 2 months.
•
•
•
•
•
Inserting and Replacing Batteries
Y our air conditioning unit may come with two
batteries(some units). Put the batteries in the
remote control before use.
1. Slide the back cover from the remote control
downward, exposing the battery compartment.
Insert the batteries, paying attention to match
up the (+) and (-) ends of the batteries with
the symbols inside the battery compartment.
Slide the battery cover back into place.
2.
3.
BATTERY NOTES
For optimum product performance:
• Do not mix old and new batteries, or
batteries of di f ferent types.
•
Do not leave batteries in the remote contr ol
if you don ’ t plan on using the device for more
than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted
municipal waste. Refer to local laws for proper
disposal of batteries.
The device could comply with the local national
regulations.
In Canada, it should comply with
CAN ICES-3(B)/NMB-3(B).
In USA, this device complies with part 15 of the
FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved
by the party responsible for compliance could
void user’s authority to operate the equipment.
Handling the Remote Controller

Strona 46

Buttons and Functions
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner , refer to the How to Use Basic Functions
section of this manual.
ON/OFF
T urns the unit on or o f f.
MODE
SWING
Sc rolls through operation
modes as follows:
AUTO  COOL  DRY
 HEAT  FAN
FAN SPEED
Selects fan speeds in the
following order:
AUTO  LOW  MED
 HIGH
SLEEP
Saves energy during
sleeping hours .
TURBO
Enables unit to reach
preset temperature in
shortest possible time.
TEMP 

Inc reases temperate in
1°C (1°F) increments.
Max. temperature is
30°C (86°F).
NOTE: Press together &
buttons at the same time
for 3 seconds will alternate
the temperature display
between the °C & °F.
TEMP 

Decreases temperate in
1°C (1°F) increments.
Min. temperature is
16°C (60°F).
TIMER ON
Sets timer to turn unit
on (see
How to Use
Basic Functions
for
instructions).
TIMER OFF
Sets timer to turn unit
of f (see
How to Use
Basic Functions
for
instructions).
DIRECT
Use to set airflow
direction.
ECO
Use to enter the energy
efficient mode.
CLEAN
LED DISPLAY
LOCK
Press together DIRECT &
TIMER OFF buttons
simultaneously for 5 seconds
to lock the keyboard. Press
together the two buttons for 2
seconds to unlock the keyboard.
Model:
RG51A(2)/E, RG51A(2)/EU1
RG51A10(2)/E(20-28 C/68-82 F)
RG51A(2)/CE(Cooling only models,
AUTO mode and HEAT mode are not available)
O O
NOTE: Cooling only
models do not have
AUTO and HEAT mode.
Used to start/stop the Self
Clean or Active Clean function.
(Model dependent, please refer
to the USER’S OPERATION &
INSTALLATION MANUAL).
Starts and stops the
horizontal louver
movement. Hold down
for 2 seconds to initiate
vertical louver auto swing
feature(some units) .
Turns indoor unit’s LED display
and air conditioner buzzer on
and off (model dependent),
which create a comfortable and
quiet environment.

Strona 47
