12
Installation
Pre-requisites for Installation
To ensure a safe and smooth installation, we recommend you go through the steps indicated below:
• Make sure that all personnel involved have read this Operation Manual thoroughly. If you have
any questions, feel free to contact your Aircel representative or the factory and we will be glad
to assist you. If you need help with the commissioning, we will be glad to schedule a factory
serviceman to visit your site and commission the dryer for a nominal fee.
• Have extra copies of the Operation Manuals.
• Special care must be taken while transporting the unit to the installation site.
• Dryer must not be moved or lifted by the attached piping.
Location
• Careful consideration should be given to the location of the dryer in order to assure optimum
results. Ensure that the load bearing weight of the floor is adequate for the weight of the dryer.
• The dryer should be located in an open area and a level ground. Dryer should be bolted to the floor
to eliminate vibrations.
• The ambient temperature should be between 40°F and 100°F. Low temperature could affect the
dryer process and result in high outlet dew point.
• In conditions where the ambient drops below freezing, Aircel recommends the use of heat trace on
any coalescing filter sumps and drain lines and the use of heated type drains.
• Dryer and accompanying filters should be installed with at least 2-5 feet clearance from the
adjoining walls to provide easy access for routine maintenance.
Typical Installation
Aircel AHLD E-Series - Models 70 - 750
Summary of Contents for AHLD E-Series
Page 38: ...38 Electrical Drawings PLC Output Sensors All AHLD E Models Aircel AHLD E Series Models 70 750...
Page 40: ...40 Electrical Drawings Back Panel All AHLD E Models Aircel AHLD E Series Models 70 750...
Page 42: ...42 Service Notes Date Service Performed Notes Aircel AHLD E Series Models 70 750...
Page 43: ...Service Notes Date Service Performed Notes Heatless Regenerative Desiccant Air Dryer 43...
