7
OTHER FEATURES / INDICATIONS
The filter’s condition is critical to the humidifier’s effectiveness. A
check filter function (
CF
) will display every 720 hours of operation to
remind the user to check the condition of the wick. Discoloration and
the development of crusty mineral deposits indicate need for
replacement of wick. Replacement may be required more often if
hard water conditions
exist.
1) This humidifier has a check filter reminder timed to appear after
720 hours of operation. When the Check Filter (CF) message is
displayed, disconnect the power cord and check the condition of
the filter. If a build-up of deposits or severe discoloration is
evident replace the filter to restore maximum efficiency. The CF
function is reset after plugging the unit back in.
2) When the unit is out of water, a flashing F will appear on the
display panel.
AUTO DRYOUT
At this time the unit will automatically switch into
AUTO DRY OUT
MODE
and continue to run on the lowest speed until the filter is
completely dry. The fan will shut off leaving you with a dry humidifier
that is less prone to mold and mildew.
If
AUTO DRY OUT MODE
is not desired, refill the humidifier with
water and the fan will return to the set speed.
WICK REPLACEMENT
The EP Series uses the 1043(CN) Super Wick. Always use the original AIRCARE
brand wick to maintain your unit and maintain your warranty.
First, remove any items on top of the pedestal
.
1) Lift chassis up off the base to reveal the wick, wick retainer and float.
2) Remove the wick and retainer assembly from base and allow excess water to
drain.
3) Remove wick from frame by squeezing the wick in a bit and pulling it through
the bottom of the frame.
4) Replace the chassis on top of the base being careful to note the front of the
unit and not damage the float when repositioning the chassis.
