EN
9. When there is not enough water in the water tank to operate the appliance, it switches off
automatically, the appliance beeps 5 times (the audible signal is not active in night mode)
and the POWER button flashes on the display.
3.4 Control by mobile app (WiFi)
You can use the “Tuya Smart” application on your smartphone or tablet (iOS, Android) to
control the device. Before the device can be controlled via the application, it is necessary to
configure the device and allow it to connect to a WiFi network.
•
The first time you turn on the device, the WiFi indicator (F) will flash quickly,
indicating that the device is not connected to a WiFi network
•
If you have already downloaded the application, then run it and follow the instructions
in the application.
•
If you have previously connected the device to a WiFi network and want to reset the
settings, then hold down the MIST button for a few seconds - the WiFi indicator will
flash again.
4 Troubleshooting
Trouble
Possible reason
Solution
Button POWER is light off.
Device is not connected to
power socket.
Connect power adapter to
device or to power socket.
Device or power adapter is
damaged.
Contact authorized service.
Button POWER is light on,
after press no action.
Device is not switch on.
Switch on device with button
POWER.
Target humidity was
reached.
Increase target humidity or
change working mode.
Button POWER is blinking
or starts to blink shortly
after start.
There is no water or very
little water in the water
tank.
Add water to the water tank
and wait for a while.
The humidifier is not on a
level surface or its upper
part is not fitted correctly.
Check the location of the
device and its top.
Unusual odor during
operation.
First start-up of the device.
Remove the filter, pour out the
water and let it stand in a cool
place for about 12 hours.
Dirty or too old water in the
tank.
Clean the water tank and
replace the water with a new
one.
Amount of evaporated
water is too small.
There is another source of
humidity in the room that
affects the humidifying
performance of the device.
Check that the windows or
doors in the room are not open
or that the air conditioning is
on.
Working mode is too low.
Set a higher operating mode
or increase the target
humidity.
Page 7 of 9
