AIR-I45756
REV 11/07/18
See Airaid.com for CARB status on each part for a specific vehicle
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions that are
not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing,
contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water.
WATER INGESTION IS THE DRIVERS RESPONSIBILITY!
The air filter is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
850-344 Airaid Oiled Media
851-344 Airaid SynthaMax Dry Media - Red
Synthamax Air Filters do not require oil. Service
air filter as needed by cleaning with common
non-petroleum all-purpose household cleaner
and water. Simple Green®, Formula 409® or
equivalent works great. Apply cleaner to outside of
air filter and allow to soak. Then flush filter clean
from the inside out with a garden hose and repeat
steps if necessary. Do not apply high pressure
water or air to clean filter. Allow filter to air dry
and reinstall.
Airaid. 1455 Citrus St., P.O. Box 1329, Riverside, CA. 92502 1-800-498-6951 [email protected] www.airaid.com
For your Oiled media filter we offer the
Airaid Tune Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
14.
Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance!
Reconnect the negative battery cable!
Continued...
7. Install the provided caplug onto the sound drum.
8. Release the clips the secure the upper air filter
housing and then remove the factory air filter. Install the
AIRAID
®
replacement air filter and resecure the upper
housing with the factory clips.
9. Install the provided coupler onto the throttle body and
secure with the provided hose clamp.
10. Install the provided coupler hose onto the air filter
housing and secure with the provided hardware.
11. Install the provided vent fittings into the AIRAID
®
intake tube as shown.
12. Install the AIRAID
®
intake tube assembly into the
coupler hoses, adjust for best fit and then secure with the
provided hose clamps. Connect the factory vent lines to
the fittings installed into the intake tube.
13. Reinstall the strut brace and decorative engine cover.