6
OPERATION
To operate
A/T SCANX ERASER.
1. Open the
A/T SCANX ERASER
lid.
2. Place Phosphor Storage Plates (PSP’s) on
A/T SCANX ERASER
tray with blue or white side of PSP’s
facing up as suggested in FIG. 3 - 8.
3. Close the
A/T SCANX ERASER
lid.
4. The
A/T SCANX ERASER
will automatically start the erasing process and run for approximately 35
seconds to completely erase the PSP’s. The Illumination Indicator will be lit during the erasing process
and will turn off upon its completion.
Cleaning Instructions:
1. Disconnect the A/T SCANX ERASER by removing the supplied line cord from the unit.
2. Wipe the glass surface underneath the lid, and the grooves of the tray using a clean, damp cloth.
3. Wipe the surfaces again until they are dry with a dry cloth.
4. Once the cleaned surfaces have dried, reconnect the supplied line cord to the A/T SCANX ERASER.
PHOSPHOR STORAGE PLATE (PSP) HANDLING
Important: Completely erase Phosphor Storage Plates (PSP’s) prior to use.
Always allow the PSP’s to remain in Eraser until completion of cycle.
Use PSP’s within 24 hours of last ersasure. Repeat erasing process if PSP’s have been stored longer
than 24 hours.
Handle PSP’s with care.
- Avoid scratching or soiling PSP’s.
- Do not bend PSP’s or apply unnecessary pressure.
- Do not store PSP’s in a hot or moist area.
- Protect the PSP’s from direct sunlight and ultraviolet rays.
- Pick up the PSP’s using two fingers around the edges to avoid unnecessary contact with the plates.
Disposal of PSP’s.
Consult with your federal, national, state and local government, for rules and regulations on
disposal of PSP’s.
