AHPCO® Cell (2018 - Present)
Replacement Instructions
3401 Airway Blvd.
Amarillo, Texas 79118
806-373-7788
®
1. Remove the screws on the
sides of the brushed aluminum
shell then remove the shell
from the base of the unit.
6. Slide shell down onto base
and replace screws. (Cord and
switch are to the back.)
2. Use a Phillips head
screwdriver to remove the
screws from the AHPCO
®
Cell.
NOTE: Before you begin please unplug the unit from it's power source.
Phillips head screwdriver or drill with Phillips head bit.
Required Tools:
3. Grasp the AHPCO® Cell and
pull to the side, then remove
the lamp connector.
CAUTION
UV lamp may be hot and could cause
serious burns if not handled properly.
Please wait until AHPCO® Cell has cooled
to room temperature to remove from unit.
5. Plug in the AHPCO® Cell, slide
the reset switch. Your unit will
beep in 2 years when it is time to
replace the AHPCO® Cell.
4. Connect the lamp connector
securely onto the AHPCO® Cell
and use a Phillips head screw-
driver to tighten the screws to
secure the AHPCO® Cell.
WARNING
AHPCO® Cell contains Hg (Mercury)
and should be disposed of according
to disposal laws. Find disposal
centers at www.earth911.org.
