8
UG-681
WirelessAir
P1/P2
continued
To store the current pressure settings as the new preset #2, press and
hold P2 until the display shows “Str” (fig. 6). Release P2 and the display
will show “Str2” to indicate the settings have been stored to preset #2
(fig. 8). Both preset settings are retained even when the WDC batteries
are removed.
DOWN
Pressing DOWN will decrease the left and right pressure settings to 5 PSI,
and then send the new setting to the currently selected manifold. This
command is sent instantly, you do not need to push the middle button to
send the setting.
UP
Pressing UP will increase the left and right pressure settings by 10 PSI,
and then send the new setting to the currently selected manifold. See
“Sending New Settings”. This command is sent instantly, you do not need
to push the middle button to send the setting.
SENDING NEW SETTINGS
When new setting are sent from the WDC to a manifold, the WDC will display “FAIL” if it
does not receive any response from the manifold (fig. 9).
fig. 9
If the manifold acknowledges the new settings, the WDC will then wait for the manifold to
get to the new setpoint pressures. While it is waiting, the WDC will update the display at
one second intervals with the actual air bag pressures, and show the compressor icon (fig.
10) or dump arrow (fig. 11) to indicate the operation in progress.
The WDC will continue to update the settings until:
1. The manifold achieves the new settings, at which point the WDC returns to displaying
the current settings.
fig. 10
fig. 11
fig. 8
