2 – #8 Mounting Screws
1 – Hot/Cold Water Valve
Installation Procedures
LIST OF PARTS ENCLOSED
The AG250-003, in combination with
AG250 series foot pedals, provides
hands free faucet operation. Pedals are
ordered separately. Select from the
following three foot pedals:
AG250-403, AG250-503 or AG250-603.
Please read the instructions once through before starting.
VALVE INSTALLATION INSTRUCTIONS
-OVER-
FIG. 1
2 – Block and Brick Wall Anchors
2 – 30" Water Supply Hoses, connector 1/2" FIP x 1/2" FIP
2 – Drywall Twist In Lock Anchors
Dual Electiical
Water Valve
1/2" Inlet Port
x2
#8 Mounting
Screws
x2
Anchor
(shown drywall
type)
x2
To Water Supply
To Faucet
Connect to
the Pedal
Before mounting the AG250-003 make sure that water is turned off.
Disconnect hoses (hot and cold water) between the faucet and
water supply.
1.
Mount the AG250-003 valve to the wall in shown on FIG.1 position .
Use supplied screws and anchors to mount valve. Install them in
mounting openings on opposite corner of the unit (use 6mm/ 1/4"
drill).
2.
Connect valve's outlet ports to the faucet using provided 30" hoses.
3.
Connect the water supply hoses to the inlet ports .
4.
While connecting hoses to the valve, use minimum force to tighten
the nut in order to prevent port adapter from rotating.
5.
Connect 3.5mm Female cable from the valve body to the pedal
(see Fig. 1 and Fig. 2).
6.
Turn on water supply and check for leakage.
7.
Press the pedal, open the faucet, and adjust it to the desired water
temperature and flow rate.
8.
As long as the pedal is depressed, water will flow from the faucet.
9.
When the pedal is released, the water flow stops.
10.
AG250-403
AG250-503
AG250-603
AG250 Series Foot Pedals
Kitchen pedal with
constant flow lock
Kitchen / bathroom
pedal
Kitchen / bathroom
floor mounted pedal
1/2" Outlet Port
x2
Connect 2.5 mm power plug cable from the battery pack to the
2.5mm power jack on the valve body (see FIG 1.)
6.
Battery pack
AA battery
included
x4
2.5 mm
Power Plug
cable from
battery pack
2.5 mm
Power Jack
