USER-IN-VIEW L.E.D.
(Green light flashes 3 times, after
5 second delay, when a user is in view. The green light
flashes constantly when a user is in view during
the 7 minute start up sequence).
OBJECT LOCK SENSOR
BATTERY L.E.D.
(Yellow light flashes
indicating it is time to replace
batteries with 4 new “C” batteries).
COURTESY MANUAL FLUSH BUTTON
(Allows manual activation of
flush when needed—Toilet
model only).
VISUAL INDICATOR GUIDE
-
-
+
-
+
+
Use battery compartment wrench to remove
battery compartment tray.
Pull cover off by rotating battery side forward
and out.
Sensor Adjustor Tool comes in a built in storage
pocket.Replace after use.
ADJUSTING YOUR AUTOFLUSH
TO CHANGE ACTIVATION DISTANCE FOR THE OBJECT LOCK SENSOR:
1
Remove battery compartment tray as shown at left.
2
Remove cover and sensor adjustor tool as shown at left.
3
Replace battery compartment in AutoFlush to activate unit.
4
Press sensor range reset button shown on next page (the green L.E.D.will flash continuously when it has an object in
view for the seven minute reset period).
5
Stand at desired activation distance.
6
Use sensor adjuster tool and turn Distance Adjustment Screw all the way down and then turn slowly up until green
L.E.D. begins to flash.
7
Ensure Object Lock Sensor is not detecting stall door or wall by closing door, stepping out of sensor path and making
sure green L.E.D. is not flashing. If sensor locks onto door or wall, unit will not flush properly. Shorten activation distance.
8
Remove battery compartment, replace sensor adjustor tool and cover. Replace battery compartment tray to reactivate
AutoFlush unit.
9
After 7 minute start-up sequence, the green L.E.D. will flash only 3 times when a user is in view
(after a 5 second delay).
