Page 8
TurboJet Max & Max II
DUCT CLEANING PROCEDURES
(CONTINUED)
7.
Then turn on the start switch
and the power light will go on
and the blower motor will start
providing strong suction. If a 20
amp Power outlet is used. The
TurboJet Max will run on 15 amp
or 20 amp circuits.
8.
The TurboJet Max 2 can be
set to “High” speed.
Follow recommended
procedure to clean each supply,
beginning at the most distant
one, using the BrushMaster
Power Brush System,
Sidewinder or Air Whisk (sold
separately).
9.
After all ducts are cleaned,
the ducts can be fogged with an
EPA registered Deodorizer and
Soot Set Sealer.
10.
Before fogging the supplies, turn off the power switch.
11.
Remove hose from the top of the TurboJet.
12.
Place a piece of pellon, 20” X 22” over the 12” inlet.
13.
Re-install the hose, and turn on the power switch.
14.
Fog the supplies, beginning with the most distant supply.
15.
When the fogging is complete, turn off the power; remove the hose from the TurboJet and the
supply duct.
16.
Remove and discard pellon.
17.
Inspect first stage filter, if loaded with debris, Dump it out or replace as required.
18.
Inspect electrostatic flex filter and wash if soiled.
19.
Unplug power cords, put TurboJet back into the vehicle, and complete the job.
Summary of Contents for TURBOJET MAX
Page 1: ...Page 1...
