Aiphone JB-2HD Installation & Operation Manual Download Page 2

- 2 -

7. Do not puncture the LCD panel with a sharp-edged tool. Damage to the LCD 

panel could occur, causing a liquid crystal spill. If liquid crystal makes contact 
with the eyes or mouth, immediately wash away with water.

8. Do not subject the monitor of the video entry security system to pressure. If 

fractured, injury could result.

9. Do not use a power supply with a voltage other than specified. Fire or electric 

shock could result.

CAUTION

(Negligence could result in injury to people or damage to property)

1. Before turning on the power, make sure wires are not crossed or shorted. Fire or 

electric shock could result.

2. Mount the unit onto the wall in a place where it cannot be easily jarred or 

bumped by people. Injury could result.

3. Do not make any wiring connections while the power supply is turned on. 

Electric shock or unit trouble could result.

4. Do not install or use the unit in any of the following places. · Places in direct 

sunlight, or near heating equipment that varies in temperature. · Places subject to 
metal particles, dust, oil, chemicals. · Places subject to moisture and humidity 
extremes, such as bathrooms, cellars, greenhouses, etc. · Places where the 
temperature is quite low, such as inside a refrigerated area or in front of an air-
conditioner.

5. Do not cover the unit with a cloth, etc. Fire or unit trouble could result.
6. Use Aiphone Power Supply or specified one by Aiphone. If not used, it may be a 

possible cause of fire or malfunction.

GENERAL PRECAUTIONS

1. This unit is for indoor use only. Do not use outdoors.
2. When wall-mounted, the unit may become black and sooty. This does not 

indicate unit trouble.

3. In areas where broadcasting station antennas are close by, the intercom system 

may be affected by radio frequency interference.

4. The unit may become a little warm with use, but this is not a malfunction.
5. If a cellular phone is used close by, the unit may malfunction.
6. It must be noted in advance that the LCD panel, though manufactured with very 

high precision techniques, inevitably will have a very small portion of its picture 
elements always lit or not lit at all. This is not considered a unit malfunction.

7. Keep the unit more than 1 m away from radio or TV sets.
8. If the monitor station is operated near office equipment, radios or TVs, it will be 

affected by radio wave interference or noise. Carefully select the place of use.

9. Ambient noise around the unit may prevent normal communication. This is not 

unit trouble.

10.As to other manufacturer's devices, such as sensor, used with this system, 

comply with the relative specifications and warranty conditions of the devices.

General Prohibitions

General Precautions

Prohibitions on Dismantling the Unit

Prohibitions on Subjecting the Unit to Water

WARNING

(Negligence could result in death or serious injury to people)

1. High voltage is present internally. Do not open the case. Electric shock could 

result.

2. Do not dismantle or alter the unit. Fire or electric shock could result.
3. Do not connect any power source other than specified to ter, -, nor 

install 2 power supplies in parallel to single input. Fire or unit damage could 
result.

4. Keep the unit away from water or any other liquid. Fire or electric shock could 

result.

5. Do not put any metal into the unit through the openings. Fire or electric shock 

could result.

6. When existing chime wiring is used, it is possible that it contains AC power. 

Unit damage or electric shock could result. Ask a qualified electrician.

7. Do not puncture the LCD panel with a sharp-edged tool. Damage to the LCD 

panel could occur, causing a liquid crystal spill. If liquid crystal makes contact 
with the eyes or mouth, immediately wash away with water.

8. Do not subject the monitor of the video entry security system to pressure. If 

fractured, injury could result.

9. Do not use a power supply with a voltage other than specified. Fire or electric 

shock could result.

CAUTION

(Negligence could result in injury to people or damage to property)

1. Before turning on the power, make sure wires are not crossed or shorted. Fire or 

electric shock could result.

2. Mount the unit onto the wall in a place where it cannot be easily jarred or 

bumped by people. Injury could result.

3. Do not make any wiring connections while the power supply is turned on. 

Electric shock or unit trouble could result.

4. Do not install or use the unit in any of the following places. · Places in direct 

sunlight, or near heating equipment that varies in temperature. · Places subject to 
metal particles, dust, oil, chemicals. · Places subject to moisture and humidity 
extremes, such as bathrooms, cellars, greenhouses, etc. · Places where the 
temperature is quite low, such as inside a refrigerated area or in front of an air-
conditioner.

5. Do not cover the unit with a cloth, etc. Fire or unit trouble could result.
6. Use Aiphone Power Supply or specified one by Aiphone. If not used, it may be a 

possible cause of fire or malfunction.

GENERAL PRECAUTIONS

1. This unit is for indoor use only. Do not use outdoors.
2. When wall-mounted, the unit may become black and sooty. This does not 

indicate unit trouble.

3. In areas where broadcasting station antennas are close by, the intercom system 

may be affected by radio frequency interference.

4. The unit may become a little warm with use, but this is not a malfunction.
5. If a cellular phone is used close by, the unit may malfunction.
6. It must be noted in advance that the LCD panel, though manufactured with very 

high precision techniques, inevitably will have a very small portion of its picture 
elements always lit or not lit at all. This is not considered a unit malfunction.

7. Keep the unit more than 1 m away from radio or TV sets.
8. If the monitor station is operated near office equipment, radios or TVs, it will be 

affected by radio wave interference or noise. Carefully select the place of use.

9. Ambient noise around the unit may prevent normal communication. This is not 

unit trouble.

10.As to other manufacturer's devices, such as sensor, used with this system, 

comply with the relative specifications and warranty conditions of the devices.

PRECAUTIONS

PRECAUTIONS

PRECAUTIONS

English

General Prohibitions

General Precautions

Prohibitions on Dismantling the Unit

Prohibitions on Subjecting the Unit to Water

WARNING

(Negligence could result in death or serious injury to people)

1. High voltage is present internally. Do not open the case. Electric shock could 

result.

2. Do not dismantle or alter the unit. Fire or electric shock could result.
3. Do not connect any power source other than specified to ter, -, nor 

install 2 power supplies in parallel to single input. Fire or unit damage could 
result.

4. Keep the unit away from water or any other liquid. Fire or electric shock could 

result.

5. Do not put any metal into the unit through the openings. Fire or electric shock 

could result.

6. When existing chime wiring is used, it is possible that it contains AC power. 

Unit damage or electric shock could result. Ask a qualified electrician.

Français

Deutsch

General Prohibitions

General Precautions

Prohibitions on Dismantling the Unit

Prohibitions on Subjecting the Unit to Water

WARNING

(Negligence could result in death or serious injury to people)

1. High voltage is present internally. Do not open the case. Electric shock could 

result.

2. Do not dismantle or alter the unit. Fire or electric shock could result.
3. Do not connect any power source other than specified to ter, -, nor 

install 2 power supplies in parallel to single input. Fire or unit damage could 
result.

4. Keep the unit away from water or any other liquid. Fire or electric shock could 

result.

5. Do not put any metal into the unit through the openings. Fire or electric shock 

could result.

6. When existing chime wiring is used, it is possible that it contains AC power. 

Unit damage or electric shock could result. Ask a qualified electrician.

7. Do not puncture the LCD panel with a sharp-edged tool. Damage to the LCD 

panel could occur, causing a liquid crystal spill. If liquid crystal makes contact 
with the eyes or mouth, immediately wash away with water.

8. Do not subject the monitor of the video entry security system to pressure. If 

fractured, injury could result.

9. Do not use a power supply with a voltage other than specified. Fire or electric 

shock could result.

CAUTION

(Negligence could result in injury to people or damage to property)

1. Before turning on the power, make sure wires are not crossed or shorted. Fire or 

electric shock could result.

2. Mount the unit onto the wall in a place where it cannot be easily jarred or 

bumped by people. Injury could result.

3. Do not make any wiring connections while the power supply is turned on. 

Electric shock or unit trouble could result.

4. Do not install or use the unit in any of the following places. · Places in direct 

sunlight, or near heating equipment that varies in temperature. · Places subject to 
metal particles, dust, oil, chemicals. · Places subject to moisture and humidity 
extremes, such as bathrooms, cellars, greenhouses, etc. · Places where the 
temperature is quite low, such as inside a refrigerated area or in front of an air-
conditioner.

Summary of Contents for JB-2HD


























Reviews: