Aiphone JA-2SD Installation & Operation Manual Download Page 3

- 3 -

PRECAUCION

(No seguir estas instrucciones podría causar daños físicos o

materiales)

1. Before turning on the power, make sure wires are not crossed or shorted. Fire or

electric shock could result.

2. When mounting the unit on wall, install the unit in a convenient location, but

not where it could be jarred or bumped. Injury could result.

3. While the power supply is turned on, do not make any wiring

connections.Electric shock or unit trouble could result.

4. Do not install the unit in any of the following locations.Fire, electric shock,or

unit trouble could result.

* Places under direct sunlight, or near heating equipment that varies in

temperature.

* Places subject to dust, oil, chemicals,
* Places subject to moisture and humidity extremes, such as bathroom,cellar,

greenhouse, etc.

* Places where the temperature is quite low, such as inside a refrigerated areaor

in front of air-conditioner.

PRECAUCIONES GENERALES

1. This unit is for indoor use only. Do not use outdoors.
2. In areas where broadcasting station antennas are close by, the intercom system

may be affected by radio frequency interference.

3. If a cellular phone is used close by, the unit may malfunction.
4. Keep the unit more than 1 m away from radio or TV sets.
5. If the monitor station is operated near office equipment, radios or TVs, it will

be affected by radio wave interference or noise. Carefully select the place of use.

6. Ambient noise around the unit may prevent normal communication. This is not

unit trouble.

 Algemeen verbod  

 Verbod het toestel te demonteren 

 Verbod het toestel in contact te brengen met water  

 Algemene

voorzorg

WAARSCHUWING

(niet-naleving kan de dood of ernstige verwonding van mensen

veroorzaken)

1. Do not dismantle or alter the unit. Fire or electric shock could result.
2. Do not connect any power source other than specified to ter, - nor

install 2 power supplies in parallel to single input. Fire or unit damage could
result.

3. Keep the unit away from water or any other liquid. Fire or electric shock could

result.

4. Do not put any metal into the unit through the openings. Fire or electric shock

could result.

OPGELET

(niet-naleving kan verwondingen van mensen of beschadigingen

van eigendommen veroorzaken)

1. Before turning on the power, make sure wires are not crossed or shorted. Fire or

electric shock could result.

2. When mounting the unit on wall, install the unit in a convenient location, but

not where it could be jarred or bumped. Injury could result.

3. While the power supply is turned on, do not make any wiring

connections.Electric shock or unit trouble could result.

4. Do not install the unit in any of the following locations.Fire, electric shock,or

unit trouble could result.

* Places under direct sunlight, or near heating equipment that varies in

temperature.

* Places subject to dust, oil, chemicals,
* Places subject to moisture and humidity extremes, such as bathroom,cellar,

greenhouse, etc.

* Places where the temperature is quite low, such as inside a refrigerated areaor

in front of air-conditioner.

ALGEMENE VOORZORGSMAATREGELEN

1. This unit is for indoor use only. Do not use outdoors.
2. In areas where broadcasting station antennas are close by, the intercom system

may be affected by radio frequency interference.

3. If a cellular phone is used close by, the unit may malfunction.
4. Keep the unit more than 1 m away from radio or TV sets.
5. If the monitor station is operated near office equipment, radios or TVs, it will

be affected by radio wave interference or noise. Carefully select the place of use.

6. Ambient noise around the unit may prevent normal communication. This is not

unit trouble.

INSTALLATION
INSTALLATION
EINBAU
INSTALACIÓN
INSTALLATIE

1-1

WIRING

English

Wiring method

Wire the inside stations in a station-to-station manner.

Cable

1. Parallel cable or single-sheathed cable are recommended.

Vinyl jacket, PE(polyethylene) insulation cable is
recommended.

2. Never use loose wires, twisted pair cable or coaxial cable.
3. When using existing wires, which may contain unused wires,

it is suggested to terminate both ends of unused pair(s) with a
120

 resistor.

WIRING

Français

Wiring method

Wire the inside stations in a station-to-station manner.

Cable

1. Parallel cable or single-sheathed cable are recommended.

Vinyl jacket, PE(polyethylene) insulation cable is
recommended.

2. Never use loose wires, twisted pair cable or coaxial cable.
3. When using existing wires, which may contain unused wires,

it is suggested to terminate both ends of unused pair(s) with a
120

 resistor.

Summary of Contents for JA-2SD













Reviews: