MAELSTROM BASS DRIVE
18
INPUT/OUTPUT PCB
Almost done! Get the two input/output jacks, the DC jack and the wire header and snap them in place.
The PCB is designed for them to fit securely, so you can do them all at once before flipping and soldering.
After you’ve soldered everything, make sure to
snip the leads on the I/O jacks as close as possible to
the PCB
. There’s not a lot of clearance between the bottom of this board and the top of the main PCB
once everything is in place, and you don’t want the pins to short against anything on accident.
PARTS
Input & output jacks
DC jack
Wire header
