AIME T600 Workstation
Artificial Intelligence
Machines
4/13
2. Important Safety Instructions
CAUTION - RISK OF ELECTRIC SHOCK!
WATCH OUT! When using the workstation, the basic
safety rules must always be followed to avoid
injuries, overvoltage, fire and electric shock:
1. Follow the manufacturer's instructions and safety
instructions during installation. Failure to do so can
damage the device and cause serious injury or death.
2. The device operates on high voltage. Never open
the device and do not try to repair it. Above all, never
open the power supply - not even when it is switched
off - there is a risk to life and can lead to injuries,
overvoltage, fire and electric shock!
3. This product is only intended for indoor use.
4. Do not use the device near water or at high
temperatures or in environments with high humidity.
5. Do not use the device during thunderstorms. In the
event of a thunderstorm, pull the power plug from
the power supply to protect it from damage caused
by lightning and overvoltage and to protect people.
6. Do not place the device near heat sources such as
fan heaters, heaters, stoves or other devices that
generate heat.
7. Do not insert any objects into the open areas of the
ventilation or fan grilles of the device.
8. The device needs adequate ventilation. Make sure
there is a distance of at least 10 cm on both sides,
front and back. Do not place any objects on the top,
the fans must remain free.
9. Do not modify any cables or connectors included
with this device.
10. Only use power cords that are compatible with
the device's power supply model. When using other
cables, the contacts may not be compatible, which
can seriously damage your device.
11. Modifications inside the device are only to be
carried out by a specialist. Before starting such work,
switch off the device and pull out the main power
plug. ESD protective measures must be observed
during all work.
12. Failure to observe the manufacturer's
instructions or one of these safety instructions, as
well as opening the device or removing, severing or
damaging one of the guarantee seals leads to the
immediate loss of all warranty and guarantee claims.
13. This device has been developed in such a way
that all specified EN classifications are only met if it
is used within a completely closed metal housing.
14. Make sure that your data is backed up regularly
to prevent data loss due to faulty data carriers,
memory modules and other hardware and software
errors or malware. In the event of a defect, the data
can then quickly be restored.
*: Notes on ESD protection
Electronic components are very sensitive to electrostatic
discharge. Therefore, never touch chips and contacts on circuit
boards directly, but only on the outer edges of the circuit board
without touching contacts or components. Ensure electrical
grounding on the housing or on metallic objects, e.g. radiators.
The following applies for 4x GPU configuration:
The T600 is supplied with two power adapters
due to its increased power requirements when
configured with 4x GPUs.
It is important to keep in mind to only operate
the device when both power adapters are
plugged in and turned on.
CAUTION: To prevent damage to the device both
power adapters have to be connected to the
power grid via the IEC cables before turning the
device on. Also both power adapters should be
turned on at the back of the device. Only then
the workstation should be started by touching
the switch on the front panel!
