19
6.2 CHARGING THE BATTERY PACK
1. Plug charger power plug into a
socket. The power lamp should
light.
2. Load battery pack into charger.
• Align battery in charger using
alignment marks and place
battery onto charger dock.
• Slide battery pack forward in
the direction of the arrow.
3. Unload battery pack after
charging, and unplug charger
from socket.
Orange
Power
lamp
Alignment mark
AC100V
Green
Charging state lamp
Slide loading type Lithium-ion
rapid charger AC100V (225VA)
50/60Hz (with 2-pin plug)
Weight: ~ 0.9 kg
Service temperature 0°~40°
Use dedicated power plug only.
When to replace the battery pack
Depending on work conditions, the battery pack will perform
approximately 500 charge/discharge cycles. It is time to replace
the battery pack with a new one when the length of charge life
decreases to half despite an initial full charge.
Battery pack storage
Store lithium-ion battery packs without charge after use. Remove
any foreign matter from terminals. Cover battery using pack cover,
which helps avoid short circuits and protects terminals from debris.
Do not store batteries in a hot or humid place.
Battery pack recycling
The Lithium-ion battery pack is recyclable, and should not be
mixed with general household waste. Return used battery packs to
the distributor who sold them to you. Cover terminals of the battery
pack with insulating tape to avoid short circuit for return shipment.
Summary of Contents for UBX-T Series
Page 22: ...7 UBX EXPLODED VIEW ...
