5
6.
Slide the rotating plate over the backbox and on top of the
tile. Again, keep the painted side towards the cover.
See Figure 3.
7.
Secure the M3 screws and washers onto the studs in the tile.
Make sure the washers overlap the rotating plate.
See Figure 4.
Figure 2: Mounting Feet Assembly
Figure 3: Assembling Mounting Kit
5. Position the tile through the backbox making sure the painted
side of the tile is towards the cover.
See Figure 3
.
Figure 4: Tile Assembly
8.
Secure the HS9369 or HS9370 to the rotating plate by attach-
ing the six M5 screws through the mounting holes in the back-
box and into the rotating plate. Do not tighten at this time.
See Figure 5.
Figure 5: Securing the Unit to Mounting Kit
9.
Position the unit into the ceiling opening. If ceiling opening is
larger than the tile, install additional "T" rails as necessary.
10. Rotate the HS9369 or HS9370 unit to the desired location and
tighten the M5 screws. Attach safety support wire.
11. Attach the camera to the camera bracket using the 1/4-20
screw provided in the hardware kit.
12. Make all necessary electrical connections.
13. Adjust the camera bracket position to the desired location and
tighten the two M6 hex bolts using an M10 (10 mm) wrench or
socket.
14. Close and lock the cover.
HS 9369 & 9370
Rubber Feet (4X)
Rotating Plate
Tile
HS 9369 & 9370
Rotating Plate
M5 x 12 Screws (8X)
Rotating Plate
M3 x 4 Screw (3X)
M3 Fender Washer
M3 Stud
Tile
