Usage and Maintenance Instructions
Ver. 1 Jun. 2012 (1258)
3
TO RETRACT
•
Position the narrowest section into the main body of the ramp. Do this by
pressing button 2 whilst pushing the narrowest section into the body of
the ramp.
•
To complete the retraction operation, continue to push the narrowest
section into the body of the ramp whilst pressing button 3. Do this until
the ramp is locked into position.
•
Repeat this for the other ramp.
MAINTENANCE & SAFETY
•
Regularly check your ramps for worn, loose or damaged parts – If you find
any of these to be damaged you must not use your ramps and you must
contact your dealer immediately.
•
Always use both ramps, and ensure they are level and parallel to each
other.
•
Ensure ramps are fully extended and locked in position.
•
Do not attempt to use ramps on gradients above 1 in 12. Please also check
the gradient your wheelchair or scooter is capable of.
•
Do not exceed the weight capacity of the ramps.
•
Only allow one person/ mobility vehicle to use the ramps at once.
•
The surface of the ramps may become slippery in icy or wet conditions.
Please exercise caution in these conditions.
•
Keep your ramps clean of any dirt or debris as this could interfere with its
sliding motion.
•
Always use the ramps in line with the wheelchairs/scooter manufacturer’s
guidelines; NEVER use it at a steeper gradient than recommended.
•
Do not modify or add to your ramp as it could void any warranty claims.
•
Do not use the ramp for anything other than its original intended purpose.
•
Only clean your ramps with mild detergent.
•
Use caution when adjusting the length of your ramps and avoid any pinch
points.
CLEANING
Clean your Ramps using a mild detergent with a slightly damp, soft cloth only.
Only use a mild detergent or disinfectant; never use an abrasive cleaner.
After cleaning, leave the Ramps somewhere warm and dry to air or wipe over
with a dry, soft cloth. Do not leave in direct contact with a heat source.
