Aico SmartLINK Ei3000MRF, Instruction Manual

Page: 11 / 24

The Ei3000MRF SmartLINK Module provides additional features not available
with Ei Electronics RadioLINK products. The following features will only work with
SmartLINK devices.
1. Remote House Coding (required if you want to add an Alarm to an installed system)
2. Monitoring
3. Data Extraction
*Note these functions will not be available unless you have completed House Code Entry.
1. Remote House Coding
If it is necessary to extend an RF system or you find that you want to add an extra
Alarm to a system you can now do so quite simply via the ‘Remote House Coding’
feature. Firstly using a screwdriver, press and hold the House Code button of one of
the previously installed Alarms until you see all colours flashing (red, blue, green).
Immediately release the button. This Alarm will now send an RF message to all the
previously installed (compatible) devices to re-enter House Code mode. Similarly,
install and put the new Alarm you wish to add to the system into House Code mode
(see “Installation and House Coding” section). As before, allow sufficient time so
that all Alarms are now house coded correctly (this can be confirmed by counting
the number of flashes on each Alarm). You can then exit House Code mode
manually or let it exit automatically after 30 minutes. (N.B. for this feature to work
all devices in the system must be SmartLINK).
10
Additional Features