2. Controls
1. Envelope Out
.
The brightness of this LED
indicates the level of the output.
2. Loop / Envelope Toggle
.
This toggle selects the
two modes of the Looping Envelope Generator,
Loop or Envelope.
3. Manual Trigger.
In Envelope mode, this button
will manually activate an AD Trigger when either of
the following are true: 1) There is no cable in the
Gate input, or 2) There is a cable in the gate input,
and a gate signal is present.
4. Trigger Input.
In Envelope mode, when the
trigger input voltage is high (from a clock, keyboard,
or lfo for example) an AD Trigger will activate when
either of the following are true: 1) There is no cable
in the Gate input, or 2) There is a cable in the gate
input, and a gate signal is present.
5. Gate Input.
In Envelope mode, when the gate
input voltage is high (from a clock, keyboard, or lfo
for example) an ADSR Envelope will activate.
6. Attack.
In Envelope and Loop mode, the position
of this knob sets the Attack time, or the time it takes
for the Output to go from 0 voltage at the start of an
ADSR envelope, AD Trigger, or AD loop, to
maximum voltage. Times range from 20ms to 14 seconds.
7. Decay.
In Envelope and Loop mode, the position of this knob sets the Decay time, or the time it takes for
the Output to go from maximum voltage after the Attack Phase to either 0 Voltage of an AD Trigger, or to the
Sustain Level of an ADSR Envelope or AD Trigger. Times range from 10ms to 20 seconds.
8. Sustain.
In Envelope mode, the position of this knob sets the level of the Output voltage while gate is true
(a key is held). In AD Trigger mode, the position of this knob sets the return voltage, and the knob must be set
to zero in order to “reset.”
9. Release.
In Envelope mode, the position of this knob sets the time it takes for the Output voltage to return
to zero from the sustain level when gate is False. Times range from 100ms to 7 seconds.
10. Out.
This is the primary voltage output, with levels ranging from 0 to 7.5V.
