11. BATTERY Terminal Strip
12. AUX-1 & AUX-2 Input Jacks
13. AUX-3 (CD / TAPE) Stereo Input
14. MIC-1 to MIC-12 Input Jacks
15. LINE Output Jacks (1Volt)
16. PRE Output Jacks (200mV)
17. HEADPHONES Output
19. AC Mains Cable
20. AC Fuse
For uninterrupted operation of the Mixer, a 12V
Car Battery is to be connected from this terminal
strip in correct polarity. No battery current is
consumed when the Mixer is working on AC
Mains. Changeover to battery operation is
automatic in case of AC Mains failure.
For connecting AUX input sources such as a
cassette player, additional mixer etc.
For connecting higher output level sources such
as a CD Player, Stereo Cassette Player,
Electronic Keyboard etc.
These jacks are for connecting Lo-impedance
Microphones.
These four jacks are connected in such a way
that they do not load each other. This output is
for connecting the Mixer to the LINE Input of an
amplifier.
These two jacks are for connecting to AUX input
of any amplifier or of a cassette recorder for
recording the program.
Audio output through a ¼” stereo jack for
headphone monitoring
18. EARTH Terminal
• Rear Panel Controls & Features
11
LINE
OUTPUT
1V
PRE OUT
200mV
HEADPHONES
FUSE 0.5AT
FUSE
240V ~ 50Hz
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED PERSONNEL.
THIS EQUIPMENT MUST BE EARTHED.
DISCONNECT POWER SUPPLY CORD BEFORE
CHANGING FUSE OR REMOVING COVER.
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
CAUTION
12V DC
MX-15
AUX-1
100mV
MIC-10
MIC-7
MIC-4
MIC-1
AUX-2
100mV
AUX-3
(CD/TAPE)
500mV
MIC-11
MIC-8
MIC-5
MIC-2
MIC-12
MIC-9
MIC-6
MIC-3
R
L
17
16
15
20
19
18
13
14
12
Caution
!
The equipment must be earthed properly before operating it to avoid electric shock. A wire from the Earth
Terminal must be connected to either water pipe or to electrical earth for safe operation.
3
MX-15
