8
• Setup & Operations
LXA-7600
Stereo Mode Configuration
In STEREO mode, both channels A & B are fully independent of each other. The balanced / unbalanced inputs
can be connected either to a stereo signal source or two independent mono signal sources. Each channel can
separately drive loudspeaker loads of 8/4/2 ohms.
+
Adjust the individual volume controls of each
channel on the front panel to obtain the desired
output level.
+
The signal indicator LEDs glow to indicate the
presence of signal at the output terminals.
+
Adjust the input signal level below the threshold of
clip LED glow.
+
To select STEREO mode, keep the slide switch,
provided at rear panel, in STEREO position.
+
Connect a speaker system on the output terminal of
each channel. It is recommended to use the
speakon connectors and wire these as per fig. 3
(Output Connections for Stereo / Mono Mode)
.
+
Connect the Left and Right outputs of a mixer to
channel A and B inputs of the amplifier respectively.
Inputs can be wired as per fig. 1 & 2
(Input
Connections for Balanced and Unbalanced Mode)
.
9
• Setup & Operations…
LXA-7600
+
To select MONO mode, keep the slide switch,
provided at rear panel, in MONO position.
+
Connect a speaker system on the output terminal of
each channel. It is recommended to use the
speakon connectors and wire these as per fig. 3
(Output Connections for Stereo / Mono Mode)
.
+
Connect the line output of a mixer to channel A
input of the amplifier. Input can be wired as per fig.
1 & 2
(Input Connections for Balanced and
Unbalanced Mode)
.
+
The desired output levels of the A & B channels are
adjustable by individual control of channel A & B
respectively.
+
The signal indicator LEDs glow to indicate the
presence of signal.
+
Operate the amplifier below the onset of clip LED
glow. Continuous clip LED glow may push amplifier
into protect mode.
When operating in MONO mode, the signal source should be connected to the balanced / unbalanced input of
channel A only
. Both channels provide similar output to their respective loudspeakers. Each channel can
separately drive loudspeaker loads of 8/4/2 ohms.
Multiple
Speaker System (4
W
)
Multiple
Speaker System (4
W
)
CH. B Output
CH. A Output
CD Player
AMX-1412
PA Mixer
Microphones
R
Play Input
Line Output
L
LXA-7600
Wireless Microphone
CH. B Input
CH. A Input
Mono Mode Configuration
CH. A Input
CD Player
PA Mixer
Microphones
Play Input
Line Output
LXA-7600
Multiple
Speaker System (4
W
)
Multiple
Speaker System (4
W
)
Wireless Microphone
CH. B Output
CH. A Output
