ahlsell QF100HTX5CON, Installation Instructions Manual

Page: 3 / 28

ACCESSORIES
(not supplied)
WALL FITTING KIT
A range of 100 mm wall kits are available for installing into most walls using liners supplied.
INSTALLATION
IMPORTANT: The fan should only be used in conjunction with fixed wiring.
PANEL/CEILING MOUNTING
1. For panel/ceiling mounting the fan should be installed into a closed duct protected by an exterior air grille that
must comply with the standard requirements of your country.
2. Cut a 105mm diameter hole for 100mm fans.
3. Push the two clips on each side of the fan and pull the grille away from the chassis.
4. Mark the screw centres through the holes in the fan back plate. Drill, plug and screw into position.
5. After installation, ensure impeller rotates freely and the shutters can open.
6. Replace the grille and ensure the clips reactivate.
WALL MOUNTING
1. For wall mounting either cut a 115mm diameter hole for 100mm fans, through the wall and insert the wall sleeve.
Slope the sleeve slightly downwards away from the fan. Cut to length and cement both ends into position flush
with the wall faces.
2. Push the two clips on each side of the fan and pull the grille away from the chassis.
3. Mark the screw centres through the holes in the fan back plate. Drill, plug and screw into position. Fix exterior
grille into position with the louvres positioned downwards. (Note: The grille must comply with the standard
requirements of your country. The wall kit used in this installation should provide a minimum ducting length of
100 mm from the fans back plate to the inside of the external grille).
4. After installation, ensure impeller rotates freely and the shutters can open.
5. Replace the grille and ensure the clips reactivate.
3
L. Stationary appliances not fitted with means for disconnection from the
supply mains having a contact separation in all poles that provide full
disconnection under over voltage category III, the instructions state that
means for disconnection must be incorporated in the fixed wiring in
accordance with the wiring rules.
M. Ensure the grille is fully engaged onto the fan chassis using all clips.
N. Cleaning and user maintenance shall not be made by children.
EN