ahlsell 7704527, Installation Instructions Manual

Page: 3 / 20

3 2
EN EN
Instruction for Light Source Disassembly
Basic
1 2
3 4
Maintenance
1. Cut off the main power first
2. Don’t touch LEDs while maintaining or cleaning
3. Don’t use chemicals to clean the fixture.
Environmental protection: waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.
Caution:
1. The product must be installed by professional technicians and power supply must be cut off before installation.
2. The diameter for AC input wire is 0.75mm² (complying with 60245 IEC57), which complies with the latest IEE electrical
standards or national standards.
3. Do not touch the electronic circuit and its components.
4. Contact an authorised technical service centre for any repairs possibly required use only original spare parts.
5. Do not touch LED while installing or maintaining.
6. Sealing the entrance hole with glue after install is needed.
7. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar
qualified person.
Remove the screws, cover and diffuser.
Twist the securing lug on PCBA to OPEN.
Remove the plastic rivets.
Use a flat head screwdriver to pry the DC cover off
the driver, and pull out the DC cable.
Remove the light source from PCBA.