10. Measuring using Measuring-Menus
Single manual measuring point scan:
<MANU>
The following symbols will,
for a short period,
be indicated in the
status line
:
The start arrow will light up and then go off again
´
©
´
Lightening up in case of data output via interface
´
COM
´
Indicated when measured values are being stored (s. 11.1.2)
´
REC
´
Each time the key is pressed again after this, the measured values are equally
processed with the corresponding measuring time.
10.3.2 Cyclic Output / Storage of all Measuring Points
For cyclic outputs of measured values (s. man. 6.5.1.2) and recording, the cy-
cle and the output format have to be programmed. The measurement can be
started
by pressing the key
<START>
and
stopped
with the key
<STOP>
. At
each start of a measurement the max, min and average values of all measur-
ing points are cleared, if the device has been correspondingly configured (stan-
dard setting, s. 11.5.8).
The function
Cycle Timer
indicates the cycle as long as a measurement has
not been started. After selecting the function (s. 9.4), the cycle can be entered
immediately (s. 9.5). After starting a measurement you can see the timer
counting down to the next cycle.
Function
Cycle Timer
:
Cycle Timer:
00:02:00
S
Cycle (
hh:mm:ss
), Memory On, Format List
The key
<FORM>
can be used as the quickest way to set the required Output
Format (printouts s. man. 6.6.1).
Change format:
<FORM>
Format columns next to each other ´
n
´:
Cycle Timer:
00:02:00
Sn
Change format:
<FORM>
Format table ´
t
´:
Cycle Timer:
00:02:00
St
Starting a cyclic measuring point scan wih key:
<START>
For control purposes the following symbols will
continuously
, i.e. for the whole
meas.period, be indicated in the
status line
:
The start arrow lights up
´
©
´
Lightening up in case of a data output via interface
´
COM
´
Indicated when measured values are being stored (s. 11.1.2)
´
REC
´
Stopping a cyclic measuring point scan with key:
<STOP>
´
ll
´
10.3.3 Memory space, Memory Output, Clearing the Memory
The function
MemoryFreei
allows, during recording of measuring data, to con-
tinuously monitor the available memory space. By selecting this function, two
soft keys are available for a direct output and clearing of the memory. The out-
put format corresponds to the setting in the cycle (s. 10.3.2 and 11.1.2)
30 ALMEMO
®
2890-9
