AGT AGT-SSFM, Product Manual

Page: 21 / 27

OPERATION INSTRUCTIONS
v. If mulcher is stalling: Stop forward movement, raise mulcher, and
allow rotor to regain full speed. Also recommended to slow your
forward ground speed to help prevent stalling.
vi. If mulcher completely jams: Disengage hydraulics, lower to ground,
and stop skid steer engine. Remove key from operating unit to
prevent accidental starting. Then remove debris from rotor.
vii. Important information:
1. Pressure Gauge: Gauge should be visible from operator’s
seat and shows system pressure. If gauge reaches
maximum pressure, raise mulcher away from brush/tree,
and let it return to full RPMs. Avoid operating at maximum
pressure for extended periods; this can shorten
componentlife.
2. Push Bar: Used to push over brush and small trees. Not
for pushing large standing trees.
l. Maintenance:
i. Routine Inspections:
1. Check hoses and fittings daily for leaks.
2. Inspect unit for any contamination build up and keep unit clean.
3. Check teeth every 2 hours of use; unit life will last longer if
teeth are kept in good condition and replaced asneeded.
ii. Check Belt Tension:
1. Inspect belt for wear, damage and propertension.
2. Adjust idler to set belt tension.
iii. Replace damaged/worn teeth.
iv. Grease and oil points: Note further details on Pages 8-10.
v. Add grease to Belt Pulley Grease Point 2. Add oil to Drum Bearing Access
Point 3. Add oil to Motor Access Point.
sales@agrotkindustrial.com https://www.agrotkindustrial.com/
P20