OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
95
Fig. 101
Fig. 102
A large amount of power is consumed when the engine is started, which is why the following
must be taken into account when using the starter:
•
The started can be activated, without interruption, for a maximum of 10 seconds.
•
If the engine fails to start, wait at least 10 10 before trying again.
•
If the engine does not start after several starting attempts, stop trying to start the engine
and find out what is causing the problem.
4.11.3
ALTERNATOR
The alternator is used to maintain the required voltage of the battery and other components of the
tractor’s electrical system. It will only function properly when it is properly mechanically
fastened, properly connected to the battery and the electrical installation is not damaged.
The operator can see if the
alternator operates properly
by looking at the indicator
lamp on the dashboard.
When it operates properly,
the indicator lamp must be
turned off. The alternator
characteristics are described
in the chapter “Technical
data”.
4.11.4
ENGINE COMPUTER
The engine computer or engine control module is an electronic device that controls a series of
drives on an internal combustion engine to ensure optimal performance of the engine.
The
engine
computer
is
connected to the dashboard
through
a
Can-Bus
communication network and
sends
information
on
the
operation of the engine and
other
components
or
any
malfunctions that may occur
during operation.
Summary of Contents for AGT 106
