OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
38
Fig. 37
4.2
DESCRIPTION OF THE MAIN COMPONENTS OF THE CAB
A tractor equipped with a cab can be used for driving on the road. The cab is a
category 1
equipment and is not suitable for working with dangerous substances because it does not provide
protection for the driver in this type of work; refer to the chapter “Safety instructions for
operating the tractor during spraying”.
The illustration below shows the main
components of the cab.
1.
Cab
The cab is mounted on a frame consisting
of several platforms which are connected at
four transmission points, at the left and
right sleeve in the rear and at the
intermediate transmission section in the
front. This configuration enables easier
disassembly and assembly during repairs or
replacement of a damaged cab.
The cab is equipped with separate controls
(switches for lamps, wipers etc.), which are
independent
from
the
other
tractor
components, and it is equipped with an air
conditioner.
2.
Cab doors
The cab doors are installed on both sides of
the cab. They are designed to allow for an
easy entering and exiting of the user or the
operator.
They
also
serve
as
an
emergency exit in the event of a rollover.
Each door is also equipped with a lock.
3.
Front and rear windscreen
Both windscreens are made from toughened glass. They are opened outwards from below, by
means of a hinge installed at the top and a mechanical lever at the bottom. Each windscreen is
also fitted with a gas spring for easier opening, which automatically opens it to its maximum
stroke when the mechanical lever at the bottom is released.
Both windscreens are fitted with a single centre-mounted wiper, controlled through a separate
connector in the cab and a windscreen washing device.
4.
Working lamps
The lamps can be adjusted manually to different angles for an optimal illumination of a specific
area. There are four lamps installed on the cab, two in the front part and two in the rear (see Fig.
37).
5.
Rear-view mirrors
The rear-view mirrors must be adjusted to ensure you can safely monitor the tractor and the
implement when driving. The rear-view mirrors are correctly adjusted when the driver is easily
able to see the sides of the tractor and the implement from the operating area. The rear-view
mirrors are mandatory equipment for road driving.
6.
Cab filter
The filter prevents foul air from entering the cab.
WARNING:
The protective cab was not tested for falling objects or intrusion of
materials and is therefore NOT CERTIFIED and does not meet the conditions to
be used as protective equipment FOPS – Falling object protective structure and
OPS – Operator protective structure!
Summary of Contents for AGT 106
