OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
104
Fig. 113
5.2
UNLOADING
The procedure for unloading the tractor is carried
out in reverse order of the loading procedure.
Before driving the tractor off the transport vehicle,
make sure that the load-bearing capacity of the
loading ramp is sufficient. Adjust the position of
the ramp to the wheelbase of the tractor, see, and
securely fasten it to the transport vehicle and the
ground. Drive the tractor off the transport vehicle;
the driver must sit in the driver's seat.
5.3
TOWING
The tractor can be towed in the event of a failure or for transporting, when the tractor is loaded
onto a transport vehicle using a winch.
The tow hook is installed at the front of the tractor, in the middle of the bumper, directly under
the engine cover.
Attaching the tractor to a towing vehicle, see
•
Drive the towing vehicle to the tractor so that the tow bar can be easily attached.
•
Remove the safety pin on the bolt and pull the bolt out of the tow hook.
•
Attach the tow bar (1) to the vehicle and the tractor.
•
Insert the bolt (2) back into the tow hook on the tractor and secure it with a pin (1); the
procedure for the towing vehicle is similar.
•
When the tractor is attached to the towing vehicle, move the shift levers to neutral and
release the parking brake.
•
When towing, the driver must always remain on the seat.
•
After towing, restore the tractor to its original operating condition.
WARNING:
If the engine of the tractor is shut down when unloading the tractor,
the steering wheel is stiff and harder to turn because the hydraulic system is turned
off.
WARNING:
Do not use the front tow hook for towing other implements!
Summary of Contents for AGT 106
