7
Installation / Start up
1. Remove the packaging material.
2. Take out the stainless steel disk
3. Lift off the electrical lift from pallet
4. When moving the electrical lift with a forklift, the elevator box must be
lifted about 100 mm so the forklift legs can be fully moved under electri-
cal lift
5. The electrical lift Large / Small should be placed against a fixed, straight
wall or similar to avoid displacement when installing or removing pallets
or containers on wheels.
6. Attach the rubber band on the right and the left side.
7. Install the pallet or roller leg extensions at the right and left sides of the
elevator box.
8. Install the waste box from behind under the stainless steel disk.
9. Grounded power plug is located on the upper left side. Cable length app-
roximately 1,20 m.
10. Grounded power outlet 220/230V with ground fault switch and 10A fuse.
Placement is recommended approximately 2100 mm above floor level.
11. Turn the operating switch to position 1 to run the elevator box fully down.
12. Install a pallet or roll in a container on wheels manually (not using a fork
lift)
13. Turn the operating switch to position 2 to run the elevator box to the
upper position.
14. Put the stainless steel disk in front of the dispenser and fix it by using the
rubber band.
15. Open the hatch or cut open the octabin bottom about 140 mm high.
Summary of Contents for LARGE 250 KG
