agri supply PTOW3, Owner'S Manual

Page: 8 / 12

7. Fill priming water
WARNING:
Not allowed start water pump if water pump is not fill water fully. Not allowed
start water pump if Gearbox box is not fill to proper oil level.
STARTING THE WATER PUMP
Follow these steps to start the water pump:
1.Fill water full to water pump.
2.Fill oil to proper level to gearbox
3. Start the tractor engine
4.Choose correct gear and engage the power takeoff (PTO) drive.
5. Slowly increase tractor engine speed while observing water pump running till pump out
water
，
adjust engine speed to rated speed.
STOPPING THE WATER PUMP
Follow these steps:
1. Release the cluth, Let tractor engine run for a few minutes at no-load, to cool internal parts.
2. Shut OFF the tractor engine.
3. Clean water pump
4. Remove the power takeoff (PTO) shaft from water pump and tractor.
8. Maintenance
Your water pump set will perform reliably only if you properly maintain it. This section outlines
the minimum recommended periodic maintenance to keep your unit in good condition and
increase its life. If operating your water pump under extremely adverse conditions (extreme dust,
dirt, cold or heat), increase periodic maintenance frequencies accordingly.
VISUAL INSPECTION
Carefully inspect the water pump set before you first use it and at least once each month
thereafter. Look for the following discrepancies:
1. Loose or broken parts
2. Defective connections
3. Missing, corroded or damaged fasteners and other hardware
4. General appearance and cleanliness