7. Do not operate close to ditches or creeks. Slow down when operating
over rough ground.
8. When adjusting the angle of the moldboard assembly, be sure that your feet
are never under the rear blade.
9. Be careful to avoid catching the rear blade on stumps or other immovable
objects.
MAINTENANCE SAFETY
1. Keep all persons away from operator control area while performing
adjustments, service, or maintenance.
2. Periodically tighten all bolts, nuts and screws and check that all cotter
pins are properly installed to ensure unit is in a safe condition.
3. Never use your hands to locate a hydraulic leak on attachments. Use a small
piece of cardboard or wood.
4. Never replace hex bolts with less than grade five bolts unless otherwise
specified. Refer to bolt torque chart for head identification marking.
STORAGE SAFETY
1. Store the unit in an area away from human activity. Do not permit children to
play on or around the stored unit.
2. Make sure all parked machines are on a hard, level surface and engage
all safety devices.
3. At the end of the working season or when the box blade will not be used
for a long period, it is good practice to clean off any dirt or grease that may
have accumulated on the blade and any of the moving parts.
4. Inspect the blade for loose, damaged or worn parts and adjust or replace if
needed.
5. Repaint parts where paint is worn or scratched to prevent rust.
6. Store box blade in a clean, dry place.
ALWAYS OBEY ALL SAFETY
RULES!
ALWAYS BE CAREFUL!
