4
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(2)
3/4" Wrenches
(2)
9/16" Wrenches
(2)
1-1/8" Wrenches or Adjustable Wrenches
(1)
1-5/16" Wrench or 12" Adjustable Wrench
Remove all loose parts and the hardware package
from the shipping carton. Lay out and identify each
part and the hardware as shown on pages 2 and 3. Be
sure the carton is empty before it is discarded.
1. Attach two depth gauge bars to the frame using a
3/8" U-bolt and two 3/8" Nylock hex nuts for each
bar. Put each depth gauge bar next to each out-
side tang on the rear of the frame as shown in
figure 1. Use the holes in each bar that will give the
desired working depth, if known at this time. Use
matching holes in both depth gauge bars to keep
the cultivator level.
NOTE:
For effective depth control a depth gauge bar
must not be located directly behind a front tang.
2. Attach two mast extension straps to the front of
the frame using two 1/2" x 2-3/4" hex bolts and two
1/2" Nylock hex nuts. Point the bent end of each
strap toward the outside of the frame.
Do not
tighten yet.
See figure 2.
CAUTION: THE CULTIVATOR TANGS
HAVE SHARP POINTS. USE CARE
WHEN HANDLING AND ASSEMBLING
THE TANGS. WEAR GLOVES FOR
EXTRA PROTECTION AGAINST CUTS.
FIGURE 2
1/2" NYLOCK
HEX NUT
MAST EXTENSION
STRAP (RIGHT
SIDE)
1/2" x 2-3/4"
HEX BOLT
FRONT
FIGURE 1
3/8" NYLOCK
HEX NUT
3/8"
U-BOLT
DEPTH
GAUGE BAR
DEPTH
GAUGE
B A R
3. Attach the cross brace and the two mast sides to
the ends of the mast extension straps. The cross
brace is between the extension straps while the
mast sides are on the outside. The cross brace
and mast sides are connected to the extension
straps using two category 1 pins, two 7/8" lock
washers, and two 7/8" hex nuts.
Do not tighten
yet.
See figure 3.
WORKING
DEPTH
FIGURE 3
MAST
SIDE
CATEGORY
1 PIN
CROSS
BRACE
7/8" LOCK WASHER
7/8" HEX
NUT
EXTENSION
STRAP
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com