8
FIGURE 14
IMPORTANT: Do not
over bend the support rods
during the following step. Over bending will cause the
spring steel rods to loose supporting tension.
10. Assemble the two hopper support rods as shown in
figure 15. Place end of rod into hole in upper hopper
tube and bend rod just enough to fit bottom end of rod
into hole in bottom hopper tube.
8.
Assemble the frame strap to the lower hopper tube
using two 1/4" x 1-1/4" hex bolts and 1/4" hex lock
nuts. See figure 13.
7.
Assemble the bag retainer and the bag frame strap to
the front edge of the bag bottom. Place the bag
retainer on top and the bag frame strap underneath
the bag bottom. Fasten retainer and strap together
using six #10 x 5/8" slotted screws and #10-32 hex
lock nuts. See figure 12.
#10-32 HEX
LOCK NUT
FRAME STRAP
FRONT EDGE OF BAG BOTTOM
#10-32 x 5/8" SCREW
BAG RETAINER
FIGURE 12
FIGURE 13
1/4" x 1-1/4" HEX BOLT
(OUTSIDE)
LOWER
HOPPER
TUBE
1/4" HEX
LOCK NUT
FRAME STRAP
9.
Secure the bag corners over the lower hopper tube
by snapping the flap to the bag bottom on both sides.
See figure 14.
SNAP
FLAP
SUPPORT RODS
FIGURE 15
11. Locate (by touch) the hole in each upper hopper tube.
Pierce holes through the stitched bag flaps, aligned
with the located holes in both hopper tubes. See
figure 16.
UPPER HOPPER TUBE
FIGURE 16
