Agri-Fab 45-02212, Owner'S Manual

Page: 8 / 16

8
1/4" x 1-1/8"
CLEVIS PIN
3/32" HAIR
COTTER PIN
BAG FRAME STRAP
7. Insert the bag frame strap into the stitched sleeve
along the front edge of the bag bottom. See figure
12.
8. Assemble the bag frame strap to the holes in the
lower hopper tubes using two 1/4" x 1-1/8" clevis
pins and 3/32" hair cotter pins. See figure 12.
FIGURE 12
SNAP
FLAP
FIGURE 13
9. Secure the bag corners around the lower hopper
tubes by snapping the bag flaps to the bag bottom
on both sides. See figure 13.
SUPPORT
RODS
FIGURE 14
IMPORTANT: Do not over bend the support rods
during the following step. Over bending will cause the
spring steel rods to loose supporting tension.
10.Assemble the two hopper support rods as shown in
figure 14. Place the ends of the rod into the upper
and lower hopper tubes, bending the rod just
enough to fit into the holes in tubes.
HINT: Tip the hopper onto its back if you have trouble
reaching in to install the support rods.
SIDE HOPPER TUBE
LOWER HOLE
11.Locate the lower hole in each side hopper tube.
Pierce a hole through the hopper bag aligned with
the lower hole in each side tube. See figure 15.
FIGURE 15