AGRETO AgriCounter Load
© AGRETO electronics GmbH
page:8
6.5
Setting the parameters
For the correct registration of the loads, the parameters for position and angle
may need to be adjusted. In mode 3B the additional parameters for time
recording are available.
To open the parameter menu, briefly press the "M" key. The first parameter that
is relevant for the set operating mode appears on the display.
The name of the parameter is displayed for two seconds, then the set value
appears.
Use the "+" or "-" keys to change the value of the parameter.
Use the "M" key to change to the next parameter, the set value is saved. After
the last parameter, the first parameter is displayed again.
To exit the menu, press and hold the "M" button for three seconds, or simply
wait 10 seconds without pressing a button.
Parameter dir - Direction
This parameter sets the direction in which the level indicator on which the
AgriCounter is mounted is aligned.
LeFt = Level indicator points to left (Presetting)
Righ = Level indicator points to right
