www
www.agnos.com
AGNO’S EQUIPMENT
Instruction and Maintenance Manual
MrotatorA
Panoramic Head
Specifi cations
Fit the FC-E8 into its housing, making sure that the back of it is kept in contact with the notch on
the bracket. This allows the converter and its nodal point to be accurately positioned at the centre
of rotation of the MrotatorA.
Fasten the securing screw on the bracket side using the Allen wrench, being careful not to fasten
too tightly in order not to damage the lens.
The threaded ring nuts found on digital cameras are assembled in factory without taking into ac-
count their thread setting. For this reason, it is necessary to orientate the assembly in rotation,
according to the camera we want to use.
Proceed as follows:
1 – Assemble the converter on the housing bracket as described above
2 – Screw the camera on the converter to the bottom.
3 – Loosen the lens securing screw on the housing bracket and rotate the Camera/Converter
assembly until it is parallel to the ground.
4 – Tighten the securing screw on the housing bracket.
For ease of use, the camera can be unscrewed from the converter without disassembling it from
the MrotatorA; in this way the assembly will always be ready and set-up.
